 | | Re: IRPD
|
| (...) I have a PIC based design on my web page: (URL) that will work with any micro. I have parts description and PIC source as well as a crude board layout graphic. This one is fully automated with a left/right/both sensing capability. I also have (...) (27 years ago, 16-Nov-99, to lugnet.robotics.handyboard)
| | | | | Re: IRPD
|
| If you check (URL) you will find IRPD's with very narrow detection zones. Those are good for many applications. If you need one with wide coverage just for obstacle avoidance, check (URL) One or the other of those sites should work for you. Gary (...) (27 years ago, 16-Nov-99, to lugnet.robotics.handyboard)
| | | | | Re: HandyBoard Charging
|
| no, to do the battery run-down test, you must not have it plugged in! otherwise you'd just be powering it from the adapter, and you'd never run out of juice. so, the steps are: 1. bootload your HB with pcode_hb.s19. you should see the Interactive C (...) (27 years ago, 16-Nov-99, to lugnet.robotics.handyboard)
| | | | | Re: HandyBoard Charging
|
| Okay, I'll try it. Do I need to have the DC adapter plugged in to the (...) th (...) the (...) bei (...) pow (...) off (...) a (...) (27 years ago, 16-Nov-99, to lugnet.robotics.handyboard)
| | | | | Re: HandyBoard Charging
|
| Danny, Since you imply that your battery does not take any charge at all, it sounds to me as though your problem is: (1) fuse F1 is open, or (2) a cell in your battery pack is open, or (3) one of the battery wires or its associated PCB land is open. (...) (27 years ago, 16-Nov-99, to lugnet.robotics.handyboard)
|
|
