| | RE: A good toy to hack for the HB?--TIA
|
|
(URL) is from Damark, $60 for the same tank. (If the URL doesn't work go to www.damark.com and search for 'tank') --Chuck McManis (...) (25 years ago, 7-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Handy Board help page
|
|
Check out this link... (URL) (25 years ago, 7-Sep-99, to lugnet.robotics.handyboard)
|
|
| | RE: Parts List
|
|
I believe The Robot Store sells the kit for $170...but not including the Expansion board. Check the HB site for the site. (...) (25 years ago, 7-Sep-99, to lugnet.robotics.handyboard)
|
|
| | bad GP2D02 link
|
|
What's wrong with Barry Brouillette GP2D02 Home page?? The link: (URL) the main Handybord Page won't work. I get an error message: employees is invalid. Has anyone the correct link or saved the pages&icb local? thank you (25 years ago, 7-Sep-99, to lugnet.robotics.handyboard)
|
|
| | exp.bord analog routed trough 5&6?
|
|
Unfortunately I ruined my analog ports 0-3. Is it posible to route the expansionboard analog ports through port 5&6 of the handyboard instead of 0&1?? What do I have to do?? thank you Stephan (25 years ago, 7-Sep-99, to lugnet.robotics.handyboard)
|
|
| | A good toy to hack for the HB?--TIA
|
|
Hello all, The school year's starting and I need to commence my annual science project. I wanted a good RC car to hack. The LEGOs aren't sufficient. I don't need speed at all, actually I'd rather it be slow but I can always gear it down. But I would (...) (25 years ago, 6-Sep-99, to lugnet.robotics.handyboard)
|
|
| | RE: Use of GP2DO2
|
|
The problem could be in the power circuitry. Are the motors powered from a separate supply ? You could try placing some capacitors between the sensor's power connectors. Ronald -----Original Message----- From: Javaid Iqbal (...) (25 years ago, 6-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Use of GP2DO2
|
|
Hi all, I am using two GP2DO2 on Rug Warrior. Sensors are giving me very stable reading when motors are not running, but when motors are running the readings start jumping around. I am running the motors but the robot is static as I have placed it (...) (25 years ago, 6-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Thank you
|
|
Turns out I just needed a common ground between servos and HB Thanx all! :) Alex (25 years ago, 5-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Re: servo problem increased
|
|
Alex, My servos shutters when I first hooked them up but it was because the values were out of range. My servos work well in a range of 700 to 3800. Bye, Terry-----Original Message----- From: Alex Stewart <robotman5@hotmail.com> To: (...) (25 years ago, 5-Sep-99, to lugnet.robotics.handyboard)
|