Subject:
|
Re: servo problem increased
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 5 Sep 1999 16:29:05 GMT
|
Original-From:
|
Terry Gathright <terrygathright@home.comNOSPAM>
|
Viewed:
|
1062 times
|
| |
|
|
Alex,
My servos shutters when I first hooked them up but it was because the values
were out of range. My servos work well in a range of 700 to 3800.
Bye,
Terry-----Original Message-----
From: Alex Stewart <robotman5@hotmail.com>
To: handyboard@media.mit.edu <handyboard@media.mit.edu>
Date: Saturday, September 04, 1999 6:41 PM
Subject: servo problem increased
> Me again
>
> Now when I give servo_a5 or a7_init(1); the other servo shutters and
> nothing happens , when you unhook the sevo your not trying to drive the one
> you are kicks up but you can olny get it in varying speeds in one • direction.
> Is it possible that the chip or the part generating the PWM signal is • fried?
> all other aspects of the board work, just not the servos?
>
> Thanxx
>
> Alex
>
>
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
