 | | Re: Voice Recognition Hardware
|
|
I actually bought one of these units (used) but have been unable to find out anything at all about them beyond the canned software. Any hints as to any sources? Ken McKinnon klmckin@magmacom.com (...) (27 years ago, 27-Jul-99, to lugnet.robotics.handyboard)
|
| |
| | Re: HB Serial line speed change
|
|
(...) I haven't looked at the schematics for the handyboard for a while, but if you use an E-series processor, then I think you can go up to 12MHz (3 MHz E-Clock). I'm not sure whether the rest of the Handyboard could take the increased speed, and (...) (27 years ago, 26-Jul-99, to lugnet.robotics.handyboard)
|
| |
| | Interfacing handyboard with Basic Stamp2
|
|
Hello to everybody. I would like to ask if is possible to interface the handyboard with the basic stamp2 using not the RS232. Thanks beforehand. (27 years ago, 26-Jul-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Weak Motor
|
|
(...) It wouldnt be wise to directly connect your 12V supply to the Handy Board... even if it doesnt cause damage to your Handy Board, I dont think your motor will be able to draw sufficient current from the motor port to run properly. Rather, you (...) (27 years ago, 26-Jul-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Voice Recognition Hardware
|
|
Try to track down a company called "CoVox". These guys used to have a speech recognition device that ran on the Apple II (6502) that was pretty cool (speaker dependent of course). Also there is a speech recognition chip for use in toys the HM002 or (...) (27 years ago, 26-Jul-99, to lugnet.robotics.handyboard)
|
