To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / *6484 (-10)
  IC Code Site Address
 
(...) That was stupid! Glad I checked my email before I left. (URL) will be at /IC/code Sorry all. It was past my bedtime (10pm, not a word) (25 years ago, 17-Jul-99, to lugnet.robotics.handyboard)
 
  Re: IC Code Site is Up
 
(...) What's the URL? (25 years ago, 17-Jul-99, to lugnet.robotics.handyboard)
 
  IC Code Site is Up
 
OK, I've done it. I've made a site for code and tips. I'll take anykind of code for any board. The site's up, but barren. I'm leaving town tomarrow, and don't have enough time to get any code listed. I wanted to get it up so everybody can look at (...) (25 years ago, 17-Jul-99, to lugnet.robotics.handyboard)
 
  Re: Servo?
 
Use the servo code on the handy board website. Then connect the yellow wire to digital input 9, the red one to logic power (+5V) ,and the black to motor ground. (...) -=-=-=-=-=-=-=-=-=-=...-=-=-=-=-= Music is well said to be the speech of angels; (...) (25 years ago, 17-Jul-99, to lugnet.robotics.handyboard)
 
  Servo?
 
Hello guys. I'm new to this stuff so please help me out with this. I want to wire up two servo motors to the handy board. There are three wires to the servo motors. A red wire for 4.8 - 6 vdc, a black wire for ground, and a yellow wire for a (...) (25 years ago, 17-Jul-99, to lugnet.robotics.handyboard)
 
  Re: Yet another board
 
(...) what page was that greg??. url pointers please. thanks aaron. (25 years ago, 16-Jul-99, to lugnet.robotics.handyboard)
 
  Re: Subsumption Architecture
 
Hi Lisa, Thank you for posting the link to the ic subsumption code at (URL) downloaded the code to my handyboard and it will help me toward understanding ic . ---...--- (...) (25 years ago, 16-Jul-99, to lugnet.robotics.handyboard)
 
  Yet another board
 
Hello Everyone, I've had something of a vision, and I don't think it was spoiled food :-) And I'd like some feedback on it. Bear with me, it requires a bit of set up. After working with Handyboards, Miniboards, 6.270 Boards, BOTBoards and other (...) (25 years ago, 16-Jul-99, to lugnet.robotics.handyboard)
 
  Re: Yet another board
 
Chuck, you may find this page of interest. UC Berkeley has put a 68HC11 with a Xilinx chip together for their natcar enter.A RC car race sponsored by national semiconductor. good luck!! Greg (...) (25 years ago, 16-Jul-99, to lugnet.robotics.handyboard)
 
  Re: Subsumption Architecture
 
Thanks to all (especially Lisa Meeden) for your responses to my request for behavior control help. I'm on my way to learning! Thanks, - Nick - (25 years ago, 16-Jul-99, to lugnet.robotics.handyboard)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR