 | | Re: GCC 2.8.1 for HC11
|
|
(...) How come you didn't simply use the 2.6.3 cross-compiler? I doubt the optimizer is improved _that_ much for the HC11. (...) It was a while ago, and I don't remember how much of Carlos's work is left. It all had to be converted to the new (...) (26 years ago, 29-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Help needed! Additional info
|
|
Hi everybody! Will Bain alerted me that I was using the wrong library files. I've corrected this, but am still having the "board not responding" problem! Any help on this is still very much welcome!! Thanks and best regards, Marc msmkatz@wxs.nl (...) (26 years ago, 28-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Polaroid Sonar Device fried!!!!
|
|
(...) The most common causes would probably be: (1) Not having a transducer hooked up when the ping is initiated; (2) Having the flat flex cable plugged in backwards (you can't trust the stripe to be on the correct side! Make sure pin 1 goes to (...) (26 years ago, 28-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Help needed!
|
|
MSMKatz wrote: <snip> (...) <snip> Marc, I wonder if the hardware is perfectly ok, but you're inadvertently attempting to load the wrong software. I'm not sure where your lib_hs.lis came from or why IC automatically loads it, but I think it might be (...) (26 years ago, 28-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Polaroid Sonar Device fried!!!!
|
|
The C3279 chip ("Q1") on my sonar device fried. I checked the expansion board and it is assembled correctly. I am not sure why it would fry. I added the 0.1uF electrolytic capacitor to C7 position as stated in the sonar.html site and suggeted by an (...) (26 years ago, 28-Mar-99, to lugnet.robotics.handyboard)
|
