Subject:
|
Help needed! Additional info
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 28 Mar 1999 19:24:55 GMT
|
Original-From:
|
MSMKatz <msmkatz@%NoSpam%wxs.nl>
|
Viewed:
|
1119 times
|
| |
| |
Hi everybody!
Will Bain alerted me that I was using the wrong library files. I've
corrected this, but am still having the "board not responding" problem!
Any help on this is still very much welcome!!
Thanks and best regards,
Marc
msmkatz@wxs.nl
> Marc, I wonder if the hardware is perfectly ok, but you're inadvertently
> attempting to load the wrong software. I'm not sure where your
> lib_hs.lis came from or why IC automatically loads it, but I think it
> might be loading the wrong libraries. I was under the impression that
> the r22 files listed above were for the MIT 6.270 controller board or
> the Rug Warrior board (I can't remember which).
>
> When I start up IC, it automatically loads the files listed in
> lib_hb.lis, of which there are only two:
>
> Synchronizing with board
> Pcode version 3.10 present on board
> Loading D:\PROGRAMS\IC\libs\lib_hb.lis.
> Loading D:\PROGRAMS\IC\libs\lib_hb.c.
> Loading D:\PROGRAMS\IC\libs\lib_hb.icb.
> Initializing interrupts
> Downloading 1142 bytes (addresses 8000-8475): 1142 loaded
> Downloading 40 bytes (addresses 8476-849D): 40 loaded
> Downloading 16 bytes (addresses 849E-84AD): 16 loaded
> Code loaded.
>
> This seems to work fine on my Handy Board; perhaps you could try this on
> yours and let us know if that solves the problem. Best of luck to you!
>
> -- Will
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|