 | | Linux, and HB beta binaries: problems getting started
|
|
Handy Board list: I'm trying to get the handy board running under Linux for a robotics class at the University of Colorado. All the devel platforms are Macs but I'd like to use Linux. I'm having problems getting started, even though I've grepped all (...) (26 years ago, 5-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | RE: Could IR ranging sensors be used with Rug Warrior board as we ll
|
|
Hi, I can only speak for the GP2D02: voltage requirement 5 volts very low power range 10cm to 80cm beam width at maximum range is about 1cm 1 input bit and 1 output bit required Cheaper,smaller ,less power, and easier to hook up than sonar I see it (...) (26 years ago, 5-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Two servos, one input ?
|
|
Has anyone hooked two servo motors up to one input? I have a project that requires three servos, but two are an identical pulse. I was going to hook those two up as servo_a7 and run a 1000-1200mA current at 6 volts. I'm thinking that will give me (...) (26 years ago, 5-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Could IR ranging sensors be used with Rug Warrior board as well
|
|
Hello all: I have to ask this question: I am using a Rug Warrior Pro board and handyboard. Could the Sharp GP2d02 or the Hamatmtsu P5507 be used on the Rug Warrior as well. More specifically : What are the voltage requirements of these two? What are (...) (26 years ago, 4-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Power problems?
|
|
To all: I am currently constructing a Handy Board. Am I currently at the step (with the Handy Board) of testing it with the Interface/Charger board. The tests I performed earlier on the charger worked, and the tests so far with the Handy Board have (...) (26 years ago, 4-Mar-99, to lugnet.robotics.handyboard)
|
