 | | Re: parallel port access
|
|
has anyone tried to access the parallel port with visual basic? chen (26 years ago, 19-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: RF VIDEO?
|
|
I recall seeing a Video transmitter "Video sender" at Biway a while back actually i own one. It transmittes on the UHF and the picture quality is quite good. It's the size a colts package just twice the height, and only $20 Canadian. It has a audio (...) (26 years ago, 18-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Expansion board
|
|
I´ve some troubles with my expansion board kit. All work fine but: 1. when the motor 0 is set to go back (for example: motor(0,-50)) signal is too low (-0,1 v) red led no lite. 2. I´ve connected a polaroid range module and run sonar.c functions. The (...) (26 years ago, 18-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | please remove me from mailing list
|
|
please remove me from your mailing list it was a lot of help on my robot thanks wayne diamondw@kennecott.com (26 years ago, 18-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Interrupt Question
|
|
I'm trying to implement a hardware shaft encoder routine similar to the the one described in the Mobile Robots Book for my Handy Board. I'm using the pulse acumulator for the left encoder and TIC2 for the right shaft encoder. They are both (...) (26 years ago, 18-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Interrupt routine question
|
|
I'm trying to implement a hardware shaft encoder routine similar to the the one described in the Mobile Robots Book for my Handy Board. I'm using the pulse acumulator for the left encoder and TIC2 for the right shaft encoder. They are both (...) (26 years ago, 18-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Unsuscribe
|
|
I would like to unsuscribe from the mailing list. Thank you (26 years ago, 18-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: IR ranging unit GP2D02
|
|
Hallo Thomas, ja ja, der GP2D02 ist ein feines Ding. Gute Infos und ein Interface findes Du (URL) Spass Bernd Klein P.S. Was baust Du denn zur Zeit ? Ich beschäftige mich mit SUMO-Roboter. Derzeit baue ich einen 1000g Sumo mit Synchronantrieb. Mit (...) (26 years ago, 18-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: RF VIDEO?
|
|
Check out these cameras/transmitters: (6 URLs) thing is, they all tune into channel 59 on any television, or video capture card on a PC (even a laptop with PC Card). -- Doug (26 years ago, 18-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Linx Technologies RF Modem
|
|
I purchased the Linx Technologies HP development kit a few months ago, and I couldn't get the PC to communicate with the Handyboard. After swapping the modules around a bit, I found that one of the Receiver modules was not working. I contacted Linx, (...) (26 years ago, 18-Feb-99, to lugnet.robotics.handyboard)
|
