To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 5546
5545  |  5547
Subject: 
Re: IR ranging unit GP2D02
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Thu, 18 Feb 1999 07:41:42 GMT
Original-From: 
Bernd Klein <Bernd.Klein@pdv^spamcake^-online.de>
Viewed: 
1171 times
  
Hallo Thomas,

ja ja, der GP2D02 ist ein feines Ding. Gute Infos und ein Interface
findes Du

http://arielle.informatik.uni-kl.de/Lehre/Praktikum/Erweiterungen_HW.html#PSD

Viel Spass

Bernd Klein

P.S. Was baust Du denn zur Zeit ?

Ich beschäftige mich mit SUMO-Roboter. Derzeit baue ich einen 1000g Sumo
mit Synchronantrieb. Mit meinem 500g Sumo habe ich erfolgreich einige
Kämpfe gewonnen .

Thomas Heidel schrieb:

Hi,

I got a SHARP "GP2D02". It is a optical ranging module
for a range from 10 to 80cm (4" to 32") with a resolution
of 8 bit; non-linear ( the near feeld resolution is better ).

While it looks like a perfect robot-eye, it looks
quit difficould to connect it to the handyboard.
I will need 8 short pulses to pull the bits out
of that device.
Dose anybody know if it is in principle possible to
generate a squarewave of 0.2ms wavelenght on a
handybord. Sure, the 68hc11-timers do allow it,
but since there are other timers are allready running
I have some doubts.


Thanks for any reply.



Message is in Reply To:
  IR ranging unit GP2D02
 
Hi, I got a SHARP "GP2D02". It is a optical ranging module for a range from 10 to 80cm (4" to 32") with a resolution of 8 bit; non-linear ( the near feeld resolution is better ). While it looks like a perfect robot-eye, it looks quit difficould to (...) (26 years ago, 17-Feb-99, to lugnet.robotics.handyboard)

2 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR