 | | (no subject)
|
|
i am sorry, but i have never readied that software. to debug, use a logic probe and check all of the 28 pins of the RAM chip. address, data, and enable lines should be flashing when the HB is turned on. if you see a line stuck at 0 or 1 that might (...) (27 years ago, 17-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | Processor load
|
|
1) Is there a way to print the actual processor load onto the screen ? or another way to see for example how much load a program causes ? 2) Does anyone know what resistors i need to produce a voltage divider to measure the voltage of the battery (...) (27 years ago, 17-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | digital and analog port on HD
|
|
Hi, I want to use the digital port as an analog port input. How should I convert the digital port to analog in using programming way ? I do not quite understand the explanation on the technical manual handout. if possible, how to convert the analog (...) (27 years ago, 17-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | Polaroid 6500 Ranging System
|
|
I recently purchased a 6500 ranging system and have connected it to the HandyBoard (HB) 1.2 Expansion Board. I am using IC ver 3.1 from Newton Research Labs and loaded the sonar.c code module provided through the MIT website. The HB passed all (...) (27 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | Re: help again
|
|
check that the RxD line on the hc11 is properly pulled up to +5v through R15. also, make sure you are *HOLDING DOWN* the STOP button until the BATT light goes off. this wasn't clear from your msg. finally, try getting the HB into boot mode with the (...) (27 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
|
