 | | Can't initialize CONFIG register
|
|
Hello, Everyone: Help! I'm trying to configure the HB. Here's what I get: C:\IC> dlm config0c.s19 -port COM2 -eeprom DLM: 6811 File Downloader... etc. Using COM2 Downloading to EEPROM Downloading config0c.s19, press ESC to abort Downloading eeprom (...) (29 years ago, 11-Feb-96, to lugnet.robotics.handyboard)
|
| |
| | Re: charger board problems
|
|
You could just get an adapter that is rated for a lower voltage. Try a nine volt adapter or a universal one that you can experiment with. -Fred -- This message was composed using Articulate Systems' PowerSecretary. Please forgive any sloppiness in (...) (29 years ago, 11-Feb-96, to lugnet.robotics.handyboard)
|
| |
| | Re: charger board problems
|
|
(...) Or just use different motors. ;-) (29 years ago, 11-Feb-96, to lugnet.robotics.handyboard)
|
| |
| | charger board problems
|
|
I've managed to stick a wire onto a point in my battery pack which yields 6V. (temporary solution, at least...) However, the charger board doesn't seem to like this new arrangement much. With the lower battery voltage, too much current is flowing (...) (29 years ago, 11-Feb-96, to lugnet.robotics.handyboard)
|
| |
| | battery voltages
|
|
I'm currently trying to get 6V out of my 9.6V battery pack. (I actually looked around for a 6V one, but couldn't find one that would work...) I've opened up the pack, and can access the cell where I can get 6V. However, I'm not sure how to get a (...) (29 years ago, 11-Feb-96, to lugnet.robotics.handyboard)
|
