Subject:
|
charger board problems
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 11 Feb 1996 06:06:00 GMT
|
Original-From:
|
Jeffrey Keyzer <JKEYZER@antispamCALWEB.COM>
|
Viewed:
|
2680 times
|
| |
|
|
I've managed to stick a wire onto a point in my battery pack which
yields 6V. (temporary solution, at least...) However, the charger board
doesn't seem to like this new arrangement much. With the lower battery
voltage, too much current is flowing through both the 47 ohm charging
resistor, and the charge LED. (which both get _very_ hot...) What values
should I increase which resistors by on the board to eliminate this problem?
Perhaps I should just stick to 9.6V, and add resistors to the motors I'm
trying to run, and make life easier for myself! :-)
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
