|
| | using the MC34064 LVI
|
| Hello, This is a warning for anyone considering using the Motorola MC34064 to replace the DS1233. I have just built a couple handyboards and I had some problems getting them working. I finally tracked the problem done to the LVI. I used the MC34064 (...) (26 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
| | | | Serial line interrupt
|
| Hello all, I'm currently trying to communicate between the Handy Board and a PC (i486) using the existing serial line between the two. Sending data from the handy Board to the PC is no problem. An interrupt handler puts all incoming serial data into (...) (26 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
| | | | Connecting radio module (BiM 418 F)
|
| Hello all, I would like to be able to 'drive' my robot using the Handy Board via a radio link. For this purpose I have bought two transceivers, the Radiometrix BiM 418 F. How can I connect it to my Handy Board? The wiring is as follows (leaving out (...) (26 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
| | | | Stepper motor
|
| Hi, I trying to make a home page about interfacing handy board with stepper motors, I hope it has enought quality to add a little contibution to the handyboard effort. For now I has just two part : One is just mails I found in the mail archive about (...) (26 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
| | | | test
|
| thanks for ignoring this message! Sorry, but I have not been getting sny HB messages for a week, and I wanted to see if it was a problem at the HB end or mines. Thanks! phil (26 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
| |