Subject:
|
using the MC34064 LVI
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Mon, 6 Jul 1998 16:29:23 GMT
|
Original-From:
|
jab@dee.fct.!antispam!unl.pt
|
Viewed:
|
1116 times
|
| |
|
|
Hello,
This is a warning for anyone considering using the Motorola MC34064 to replace
the DS1233. I have just built a couple handyboards and I had some problems
getting them working. I finally tracked the problem done to the LVI. I used
the
MC34064 instead of the DS1233 because I had some laying around. WARNING the
pin
out on the two is not the same:
Pin DS1233 MC34064
1 GND *RESET
2 *RESET +5
3 +5 GND
The MC34064 can be used but it must be rotated 120 degrees so that the signals
will be correct.
-- Jeff
______________________________________________________________________
\ Jeff Loeliger Motorola SPS \
\ email: r12110@email.sps.mot.com \"/ Systems Engineering Department\
\ phone: +44-1355-56-5400 ( ) Powertrain Systems Division \
\ fax : +44-1355-56-6300 | East Kilbride, Scotland \
\_____________________________________________________________________\
Jose Antonio Barata de Oliveira
Universidade Nova de Lisboa - Dep. Eng. Electrotecnica
Quinta da Torre
P 2825 - Monte da Caparica
Portugal
TF: +351-1-2948535
FAX: +351-1-2948532
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
