 | | RE: Cheap air flow sensor
|
|
(...) Interesting. But wouldn't the air temperature change the readings? Or would you also use a temp. sensor and adjust your table scaling to take this into account? What about air pressure, same thing? -Paul (28 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Moder Identification Needed
|
|
I did a search for escap on the internet and nothing came back. Thanks BTW, it took me longer to realize that Motor was spelled wrong than it did for you to respond with the info I needed. Thanks again. Date sent: Tue, 16 Jun 1998 11:32:06 -0400 (...) (28 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Moder Identification Needed
|
|
That was fast. Thanks Date sent: Tue, 16 Jun 1998 11:32:06 -0400 From: Mike Vande Weghe <vandeweg@nameconnector.com> Organization: Parlance Corporation To: Mike Davis <ipscone@halcyon.com> Copies to: handyboard@media.mit.edu Subject: Re: Moder (...) (28 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Moder Identification Needed
|
|
Check out (URL) - Mike (...) (28 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Moder Identification Needed
|
|
I have a couple of nice motors that I would like to get some info on. They were removed from some medical recording devices. They are very small and have pretty good power. If you try to stop the motor by grabbing the bushing on the shaft, it is (...) (28 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
|
