Subject:
|
Re: Moder Identification Needed
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 16 Jun 1998 15:49:13 GMT
|
Original-From:
|
Mike Davis <IPSCONE@HALCYON.antispamCOM>
|
Viewed:
|
3472 times
|
| |
|
|
That was fast. Thanks
Date sent: Tue, 16 Jun 1998 11:32:06 -0400
From: Mike Vande Weghe <vandeweg@nameconnector.com>
Organization: Parlance Corporation
To: Mike Davis <ipscone@halcyon.com>
Copies to: handyboard@media.mit.edu
Subject: Re: Moder Identification Needed
> Check out http://www.portescap.com
>
> - Mike
>
>
>
> Mike Davis wrote:
> >
> > I have a couple of nice motors that I would like to get some info on. They were
> > removed from some medical recording devices. They are very small and have
> > pretty good power. If you try to stop the motor by grabbing the bushing on the
> > shaft, it is very difficult.
> >
> > Anyway, they don't have a brand but have the following markings.
> >
> > escap (R) E16
> > 64,1:1
> >
> > swiss made
> > TC 11 205 0
> >
> > They are about 1.9" long and .65" in diameter. Anyone know how I can get
> > some spec. on these?
> > --
> > -----------------------------------------------------------------
> > ipscone@halcyon.com Shoot-To-Win!
> >
> > Protect the 2nd Amendment! Your rights may be next!
> > -----------------------------------------------------------------
--
-----------------------------------------------------------------
ipscone@halcyon.com Shoot-To-Win!
Protect the 2nd Amendment! Your rights may be next!
-----------------------------------------------------------------
|
|
Message is in Reply To:
4 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
