Subject:
|
Re: Moder Identification Needed
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 16 Jun 1998 16:08:27 GMT
|
Original-From:
|
Mike Davis <IPSCONE@HALCYON.COMstopspammers>
|
Viewed:
|
3429 times
|
| |
|
|
I did a search for escap on the internet and nothing came back. Thanks
BTW, it took me longer to realize that Motor was spelled wrong than it did for
you to respond with the info I needed.
Thanks again.
Date sent: Tue, 16 Jun 1998 11:32:06 -0400
From: Mike Vande Weghe <vandeweg@nameconnector.com>
Organization: Parlance Corporation
To: Mike Davis <ipscone@halcyon.com>
Copies to: handyboard@media.mit.edu
Subject: Re: Moder Identification Needed
> Check out http://www.portescap.com
>
> - Mike
>
>
>
> Mike Davis wrote:
> >
> > I have a couple of nice motors that I would like to get some info on. They were
> > removed from some medical recording devices. They are very small and have
> > pretty good power. If you try to stop the motor by grabbing the bushing on the
> > shaft, it is very difficult.
> >
> > Anyway, they don't have a brand but have the following markings.
> >
> > escap (R) E16
> > 64,1:1
> >
> > swiss made
> > TC 11 205 0
> >
> > They are about 1.9" long and .65" in diameter. Anyone know how I can get
> > some spec. on these?
> > --
> > -----------------------------------------------------------------
> > ipscone@halcyon.com Shoot-To-Win!
> >
> > Protect the 2nd Amendment! Your rights may be next!
> > -----------------------------------------------------------------
--
-----------------------------------------------------------------
ipscone@halcyon.com Shoot-To-Win!
Protect the 2nd Amendment! Your rights may be next!
-----------------------------------------------------------------
|
|
Message is in Reply To:
4 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
