To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 3972
3971  |  3973
Subject: 
Re: Moder Identification Needed
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Tue, 16 Jun 1998 15:32:06 GMT
Original-From: 
Mike Vande Weghe <vandeweg@nameconnectorSAYNOTOSPAM.com>
Viewed: 
1136 times
  
Check out http://www.portescap.com

- Mike



Mike Davis wrote:

I have a couple of nice motors that I would like to get some info on.  They were
removed from some medical recording devices.  They are very small and have
pretty good power.  If you try to stop the motor by grabbing the bushing on the
shaft, it is very difficult.

Anyway, they don't have a brand but have the following markings.

escap (R) E16
64,1:1

swiss made
TC 11 205 0

They are about 1.9" long and .65" in diameter.  Anyone know how I can get
some spec. on these?
--
-----------------------------------------------------------------
ipscone@halcyon.com                                 Shoot-To-Win!

Protect the 2nd Amendment!               Your rights may be next!
-----------------------------------------------------------------



Message has 2 Replies:
  Re: Moder Identification Needed
 
That was fast. Thanks Date sent: Tue, 16 Jun 1998 11:32:06 -0400 From: Mike Vande Weghe <vandeweg@nameconnector.com> Organization: Parlance Corporation To: Mike Davis <ipscone@halcyon.com> Copies to: handyboard@media.mit.edu Subject: Re: Moder (...) (26 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
  Re: Moder Identification Needed
 
I did a search for escap on the internet and nothing came back. Thanks BTW, it took me longer to realize that Motor was spelled wrong than it did for you to respond with the info I needed. Thanks again. Date sent: Tue, 16 Jun 1998 11:32:06 -0400 (...) (26 years ago, 16-Jun-98, to lugnet.robotics.handyboard)

Message is in Reply To:
  Moder Identification Needed
 
I have a couple of nice motors that I would like to get some info on. They were removed from some medical recording devices. They are very small and have pretty good power. If you try to stop the motor by grabbing the bushing on the shaft, it is (...) (26 years ago, 16-Jun-98, to lugnet.robotics.handyboard)

4 Messages in This Thread:


Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR