|
|
 | | Re: trouble with memory
|
| well, the dim flashing of either yellow charge LEDs should not worry you. all this means is that the Handy Board is drawing some power. if you have the wall adapter plugged into the Interface/Charger board, simply switch it to "Zap" mode. now, onto (...) (27 years ago, 11-Dec-97, to lugnet.robotics.handyboard)
| | | | | trouble with memory
|
| Dear Fred Martin, I'm in deep deeeep trouble! A few weeks ago I first read about your handyboard and was very excited about it, because I was looking for a controller board for my autonomous vacuum cleaner. So I ordered the PCB from Douglas (...) (27 years ago, 11-Dec-97, to lugnet.robotics.handyboard)
| | | | | email change
|
| I know this probably isnt the right place to do this, but could you please change my email address from mdowney@eng.ua.edu to mdowney@dbtech.net Thanks....Sorry for the intrusion. Carry on! :) (27 years ago, 9-Dec-97, to lugnet.robotics.handyboard)
| | | | | (no subject)
|
| EAS is now taking orders for the Finger Board, a very small 68hc11 micro controller board with memory and I/O selects compatible to "Handy Board". You can easily design custom interface circuitry for it by using standard prototype boards. It runs (...) (27 years ago, 9-Dec-97, to lugnet.robotics.handyboard)
| | | | | Spectra sonar pin outs
|
| Here is the pin outs that you requested Randy. The board that you are talking about has a 17 pin SIP connector. What I did is remove this connector and solder a ribbon wire to the following pins: Signal Pin # (pin 17 and pin 1 should be labeled) GND (...) (27 years ago, 9-Dec-97, to lugnet.robotics.handyboard)
|
|
