 | | RE: Wireless Communication with HB
|
|
My goal is to read various input devices ie joystick, keyboard, etc. encode the data into some sort of bit or ascii stream and then transmit it to the HB for decoding and if possible transmit from the HB back to the PC for telemetry such as (...) (27 years ago, 28-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Serial Device Interfacing
|
|
B> It will be used to control a LM197x digital Attenuator which has a B> 3 wire serial interface. B> Is it possible to wiggle the output lines in such a way ? Any B> hints ? If it is a 3 wire interface, does this imply synchronous? That sounds like (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Error in bootstrap mode
|
|
Dear Sir I start a Handy Board assembly and till now my board has passed the following steps : Microprocessor Power Circuitry ---- Passed Voltage Monitor Chip ---- Passed Microprocessor and Oscillator Circuit ---- Passed The problem focused at the (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Serial Device Interfacing
|
|
OK Newbie Allert !!! I'm looking at the Handy Board as a major step up from the Basic Stamp 2, but I need to be able to send out serial messages from the digital outputs. On the BS2 it is declared as a ShiftOut instruction. It will be used to (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | New E-Mail Address Notification
|
|
Update your records! Customer BERND KLEIN has recently obtained a new e-mail address from NET@DDRESS a service of USA.NET. You can now reach this person via e-mail at bernd.klein@usa.net. This change is effective immediately. If you would like to (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
|
