 | | Re: Downloading Problems
|
|
1. don't worry about the slightly out of spec voltages, +/- 5% is just not a problem. 2. you have already demonstrated that your board HW is OK by communicating from a Windows system. therefore 3. it is probably a cabling problem from your mac. you (...) (27 years ago, 15-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Downloading Problems
|
|
Hello all, I am in the process of building my Handyboard. I have installed the CPU and some of the voltages seem suspect. For example the E-clock signal seems to be about 2.3 volts and the main system power measured at the +5 Volts terminal for the (...) (27 years ago, 15-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Vision
|
|
(...) The article I saw it in was by Steve Ciarcia, in Byte Magazine, and entitled something like "The Micron Eye". Check through Byte magazine indexes and you should find the article. The Micromint company sold kits for it, might still. Curt Mills, (...) (27 years ago, 13-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Looking for cables
|
|
I am having difficulty finding cables to connect to the headers on the Handy board. Specifically, I would like to find a 14-pin cable with a male end to connect the handy boards LCD header (U4) and a female end to connect to a header I have (...) (27 years ago, 13-Oct-97, to lugnet.robotics.handyboard)
|
| |
| | Interfacing a clock chip?
|
|
Hi folks. Has anyone had any experience/success with interfacing a Motorola 6818 or 6818A clock chip to the 68HC11? I have some of both of these chips and would like to put them to use. Does anyone know the difference between the 6818 and the 6818A (...) (27 years ago, 12-Oct-97, to lugnet.robotics.handyboard)
|
