Subject:
|
Downloading Problems
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 15 Oct 1997 01:29:25 GMT
|
Original-From:
|
R.A. Gaunt <rgaunt@ugly.u&AvoidSpam&vic.ca>
|
Viewed:
|
1620 times
|
| |
|
|
Hello all,
I am in the process of building my Handyboard. I have installed the CPU
and some of the voltages seem suspect. For example the E-clock signal
seems to be about 2.3 volts and the main system power measured at the +5
Volts terminal for the LCD connector reads 5.13 volts. However, the main
prblem is that I can not get my computer to communicate with the
Handyboard. I tested the board on a Windows machine with no problems,
however, I have a Macintosh and am using 6811 dowloade. I know that all
the cables are fine. I always get an error that says "Did not recieve
echo byte (0) from board. Check board connections and power." I have
installed the memory and LCD now and still get the same error although it
seems to work fine under Windows. One last thing. The voltage supplying
the 32 K ram reads 5.2 volts. If anyone has any ideas why my mac won't
communicate with the handyboard it would be greatly appreciated. I am
right out of ideas.
Rob Gaunt
|
|
Message has 1 Reply:
 | | Re: Downloading Problems
|
| 1. don't worry about the slightly out of spec voltages, +/- 5% is just not a problem. 2. you have already demonstrated that your board HW is OK by communicating from a Windows system. therefore 3. it is probably a cabling problem from your mac. you (...) (27 years ago, 15-Oct-97, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
