 | | When Will It Be Available?
|
|
Hi! I got to do some test multi servo-motors. I found out the expansion board is not available yet. When will it be available from vendors? I can make a simple test by using #9 digi-input though. best Regards, Mark Kim (27 years ago, 4-Aug-97, to lugnet.robotics.handyboard)
|
| |
| | Re: RC bot base
|
|
Hi, A few students here at Penn State Abington successfully controlled the Zig-Zag using a 6270 board with both a 6volt and 9.6 volt supply using a .5 or 1 ohm series resistor. If I remember correctly the current is in the 2 amp range when loaded. (...) (27 years ago, 4-Aug-97, to lugnet.robotics.handyboard)
|
| |
| | Re: RC bot base
|
|
I have that car too but I haven't tied it to the handyboard yet because it gets stuck goin sideways! Does yours?? Have you tried the motor function or just the fd() function. The motor function should be able to slow down the motors. If not, the (...) (27 years ago, 4-Aug-97, to lugnet.robotics.handyboard)
|
| |
| | serial data link
|
|
Hello All, I am trying to construct a device to replace the wires between the RS-232 converter and the Handy Board. Of the many questions involved in this sort of thing the first one I'm wondering if anybody has experience with is the matter of (...) (27 years ago, 4-Aug-97, to lugnet.robotics.handyboard)
|
| |
| | Re: IR Capture
|
|
(...) Try my IR routines available at (URL) should handle any # of data bits and any kinds of codes. e-mail me personally if you need more help. /Max (27 years ago, 3-Aug-97, to lugnet.robotics.handyboard)
|
