|
|
 | | Com port trouble with IC
|
| I recently bought a Handy Board which works fine, but my version of Interactive C wants to communicate with the board via COM1 only. The port I have available, without completely changing my computer setup, is COM3. How do you get IC to change ports (...) (27 years ago, 20-Jul-97, to lugnet.robotics.handyboard)
| | | | | Re: Voltage
|
| (...) 12v is fine. you could up go to 18v or so w/o problems. you might not even need to change the adapter. if the yellow charge LEDs light, then the batt is charging ok. it will be slower than the original pack but maybe that is not a problem for (...) (27 years ago, 20-Jul-97, to lugnet.robotics.handyboard)
| | | | | Re: assembling i/c board
|
| no, it should be just as bright. make sure you use the special low-current HLMP LEDs as specified. normal LEDs won't work right. -Fred (...) (27 years ago, 20-Jul-97, to lugnet.robotics.handyboard)
| | | | | Voltage
|
| Hello all, What is the max. voltage I can run through the handyboard. I have a 12v dry cell battery that I would like to use. If I can use a 12v battery, can I change the transformer to the handyboard charging/serial unit? Also, I am looking for a (...) (27 years ago, 20-Jul-97, to lugnet.robotics.handyboard)
| | | | | assembling i/c board
|
| Hi, Is it normal for the i/c board PWR led to not glow too intensely?...cause my PWR led is not glowing that brightly compared to my serial led. Before my PWR led did not glow at all until i resoldered some joints that look like it needed more (...) (27 years ago, 20-Jul-97, to lugnet.robotics.handyboard)
|
|
