Handy Board : 2463


Robotics / Handy Board / 2463	2462 \| 2464

Subject:	assembling i/c board
Newsgroups:	lugnet.robotics.handyboard
Date:	Sun, 20 Jul 1997 20:09:06 GMT
Original-From:	Phethsavong Prachith <PPRACHIT@ihatespamSTUDENT.UMASS.EDU>
Viewed:	705 times

Hi, Is it normal for the i/c board PWR led to not glow too intensely?...cause my PWR led is not glowing that brightly compared to my serial led. Before my PWR led did not glow at all until i resoldered some joints that look like it needed more solder. thanks, phet

Message has 1 Reply:

		Re: assembling i/c board
no, it should be just as bright. make sure you use the special low-current HLMP LEDs as specified. normal LEDs won't work right. -Fred (...) (27 years ago, 20-Jul-97, to lugnet.robotics.handyboard)

2 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search