Subject:
|
Re: assembling i/c board
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 20 Jul 1997 23:30:29 GMT
|
Original-From:
|
Fred G. Martin <fredm@media.mit.edu/Spamcake/>
|
Viewed:
|
705 times
|
| |
| |
no, it should be just as bright.
make sure you use the special low-current HLMP LEDs as specified.
normal LEDs won't work right.
-Fred
>
> Is it normal for the i/c board PWR led to not glow too
> intensely?...cause my PWR led is not glowing that brightly compared to my
> serial led. Before my PWR led did not glow at all until i resoldered some
> joints that look like it needed more solder.
>
>
> thanks,
> phet
>
>
|
|
Message is in Reply To:
| | assembling i/c board
|
| Hi, Is it normal for the i/c board PWR led to not glow too intensely?...cause my PWR led is not glowing that brightly compared to my serial led. Before my PWR led did not glow at all until i resoldered some joints that look like it needed more (...) (27 years ago, 20-Jul-97, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|