 | | Motor speed question (premature)
|
|
Hi, Sorry for my earlier question about the motor speed table. It was a bit premature. After boning up on PWM I found that the values selected represented the "fine" (i.e. less jerky) settings. There can be as many as 16 different steps that can be (...) (29 years ago, 18-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Resets
|
|
Is it possible that your battery is simply discharged? Does the board exhibit the problem when you try driving the previous motors that did not give you a problem? Regarding the charge light on the serial board, are you sure that the charge rate (...) (29 years ago, 18-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | Resets
|
|
Hi. My board was working fine until I hooked up some different motors to it today. It seems that whenever I try to drive the motors the low battery light lights up and the board gets reset. I checked the battery and it reads 8.4V before and while (...) (29 years ago, 18-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | IC 3.1b1 under Windows 3.1
|
|
Hi Jeff, Thanks for your help. To our knowledge, no one has successfully run IC 3.1b1 under Windows 3.1 with using the win32s extension. We will look into what it will take to make future releases win32s-compatible, but for now, we apologize that (...) (29 years ago, 18-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | Re:Motor speed table question
|
|
(...) Sure, why not? The way the motor speed table works is that the number is bit shifted out to the motor. Each bit gets the same ammount of time. So if you don't want your motor to move, then you bit shift all zeros. If you want it to run at a (...) (29 years ago, 17-Mar-96, to lugnet.robotics.handyboard)
|
