Subject:
|
Resets
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Mon, 18 Mar 1996 01:04:33 GMT
|
Original-From:
|
John S Seng <jseng@lulu.acns.STOPSPAMnwu.edu>
|
Viewed:
|
1991 times
|
| |
|
|
Hi. My board was working fine until I hooked up some different motors to
it today. It seems that whenever I try to drive the motors the low
battery light lights up and the board gets reset. I checked the battery
and it reads 8.4V before and while the motors are running. Also, when I
plug the board into the serial board, the charge light on the serial
board doesn't light up anymore. Any ideas? Maybe a solder came loose
somewhere. TIA.
-John
|
|
Message has 1 Reply:
 | | Re: Resets
|
| Is it possible that your battery is simply discharged? Does the board exhibit the problem when you try driving the previous motors that did not give you a problem? Regarding the charge light on the serial board, are you sure that the charge rate (...) (29 years ago, 18-Mar-96, to lugnet.robotics.handyboard)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
