 | | Holiday Tunes for Interactive-C
|
|
Happy Holidays Everyone! I have a collection of several different holiday tunes (Jingle Bells, etc...) which can be played using Interactive-C on a Handyboard (or 6.270 board). If your Hanyboard or 6.270 board is just sitting in the corner (...) (28 years ago, 29-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Polariod Sonar
|
|
I think you're right. I used a transistor to drive the INIT with its emmiter and feed the TTL signal to the base. It seems to work fine now. :) You know what's funny, I tried using a CMOS chip (HCT) and it was able to drive the INIT signal. I figure (...) (28 years ago, 28-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | Assembler for the HB
|
|
Is there a good book for Assembler for the HB? (28 years ago, 27-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | photocells
|
|
Hi, In the book "Mobile robotics -Inspiration to Implementation" the addition of a logarthmic amplifier to the o/p of a photocell is discussed. This logarithmic mapping is supposed to make the sensor more sensitive in dark rooms. Has anyone tried (...) (28 years ago, 27-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | Using a Radio Shack Fast Track
|
|
Has anyone used the Fast Track as a base for a robot and used the H-bridge in it to control the motors ?? Any link where I could find information about it ?? Thanks Oriol (28 years ago, 27-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | Test.
|
|
Test (28 years ago, 26-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Polariod Sonar
|
|
(...) Although I teach a digital electronics class based on the 74xx series, I'm certainly no expert, but here goes anyway... TTLs seem to have a very low ability to drive anything but minimal loads. Look up "drivers" in the TTL Data Book. They (...) (28 years ago, 24-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | subscribe
|
|
subscribe thanks. (a spare time Rug Warrior 'user') (28 years ago, 24-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Polaroid & Handyboard
|
|
I hooked up the sonar to the +5 and GND on the HB and it wroked fine. I used TIC3 for Echo and pin 9 of 2nd Motor driver for INIT and GND for BINH I also hooked up the sonar power leads to the 9.6V unregulated motor power header! It also worked! (...) (28 years ago, 24-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | Polariod Sonar
|
|
Hi, I'm stuck. I'm trying to use TTL output of 74 series IC's to signal to INIT. I can't get it to work properly. Here's the deal. When I touch INIT to the 5V bus, the transducer "chirps". But when I touch INIT to a high level TTL output, it doesn't (...) (28 years ago, 23-Nov-96, to lugnet.robotics.handyboard)
|
