 | | Re: Rack-and-pinion steering line tracker —Alex Nicolaou
|
| | | (...) Somewhat unrelated, but does that truck have a tight enough turning radius to actually make the corner? I tried to build a car that could do this and follow the edge of the RoboSports test pad (would you believe I have mispaced the RIS pad?!) (...) (25 years ago, 7-Jan-00, to lugnet.robotics)
|
| | | |
| | | | | LegOS Setup —David Pfeffer
|
| | | | | -----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Has anyone had any success setting up LegOS? I set it up once before, but after a hard drive crash, I couldn't get it to work anymore. I'm compiling with Cygwin, and the only problem I have is that (...) (25 years ago, 8-Jan-00, to lugnet.robotics)
|
| | | | | |
| | | | | Re: Rack-and-pinion steering line tracker —Simon Bogaert
|
| | | | (...) I don't think so, but the goal is to let the truck follow a line that it can follow (turns that are wide enough and so on) and take up the tires it encounters. At the end of the line it should sound a beep to request the emptying of its (...) (25 years ago, 19-Jan-00, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Rack-and-pinion steering line tracker —Alex Nicolaou
|
| | | | (...) (URL) for the slow response; I've been offline for a bit lately. It was the steering assembly from 8437, motorized with a belt drive. Basically there's an offset axle that pushes two tie rods to move the wheels, which are mounted on ball (...) (25 years ago, 25-Jan-00, to lugnet.robotics)
|
| | | | |
