Subject:
|
Re: Minimum system requirements for Inventor 1.5
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sat, 25 Dec 1999 15:37:30 GMT
|
Reply-To:
|
MATTDM@MATTDMstopspammers.ORG
|
Viewed:
|
717 times
|
| |
|
|
Geoff Taylor <taylor4@cadvision.com> wrote:
> What do real world users find? Am I going to be able to use it (just slowly)?
> Or should we be advising Santa that a different gift is in order? We are OK
> on all the other requirements.
It'll work, but slowly. If you feel like your kids are ready for it, you may
want to try NQC, which will run on very minimal hardware.
--
Matthew Miller ---> mattdm@mattdm.org
Quotes 'R' Us ---> http://quotes-r-us.org/
|
|
Message has 1 Reply:
 | | Re: Minimum system requirements for Inventor 1.5
|
| I have the RIS Software on several 486's at school. As mentioned, the Tutorial stuff is real slow. The Drag&Drop programming is OK; the 'flip over' a block is noticeably slower than on a fast machine. NQC and RcxCC work fine. If your kids are about (...) (25 years ago, 29-Dec-99, to lugnet.robotics)
|
Message is in Reply To:
| | Minimum system requirements for Inventor 1.5
|
| We have two children we are considering getting the Inventors kit for. Unfortunately, we only have a P-90 processor. E-mails and calls to the company only give the party line that nothing has been tested with less than a P-166. What do real world (...) (25 years ago, 24-Dec-99, to lugnet.robotics)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
