 | | Re: RCX Controlled Air Compressor Tester
|
|
(...) Thanks, Indeed, my first attempt was to use a rotational sensor positioned with the axle at the pivot point of the lever arm and tried to datalog the angular movement using DACTA Control Lab. However, the resolution of the rotation sensor (...) (27 years ago, 28-Sep-99, to lugnet.robotics, lugnet.build, lugnet.robotics.rcx)
|
| |
 | | Re: RCX Controlled Air Compressor Tester
|
|
(...) I have tried to emphasise all the time in my web pages. It has probably reached the theoretical limit of efficiency for the small pump. It will be difficult to build another compressor that can surpass his mini compressor. On the other hand, (...) (27 years ago, 28-Sep-99, to lugnet.robotics, lugnet.build, lugnet.robotics.rcx)
|
| |
 | | Re: Are any other Photobot II pictures availalbe? Suctionbot?
|
|
I've only subscribed to this robotics newsletter for a few days--and yours is the first "low-end" question I've seen. I've just started digging into the NQC stuff (not as difficult as I'd imagined, but I feel that it will be a while before I need to (...) (27 years ago, 28-Sep-99, to lugnet.robotics)
|
| |
 | | Re: What about the Micro Scout?
|
|
(...) IMHO, its a waste of plastic. The whole DDK is a big disappointment to me. The Microscout has 7 programs built in that do just about everything you can expect it to do with a single motor and a single light sensor - which is to say, not very (...) (27 years ago, 28-Sep-99, to lugnet.robotics)
|
| |
 | | Re: 5VDC Voltage Regulation
|
|
(...) You can't have the diodes on the motor because it goes in both directions. If you put a diode out there, you would have a dead short in one of the directions. Such things need to be built into the H-bridge, not the motor leads. So, I seriously (...) (27 years ago, 28-Sep-99, to lugnet.robotics)
|