 | | RE: USB->serial adapter for IR-tower
|
|
(...) I have an Entrega splitter which adds two serials, a parallel, and four USB's, and it does that kind of stuff just fine. Very cool. I've run Ethernet (10BaseT), my printer, IR, and many other things through it. The best part: the fact that it (...) (27 years ago, 9-Aug-99, to lugnet.robotics)
|
| |
 | | Re: Power steering for 8448
|
|
I don't have the 8448 or the RCX for that matter but I may have a partial solution for you. I've found that steering is a perfect application for the Micro Motor (part # 5119). The motor is very small but provides a surprising amount of torque. It (...) (27 years ago, 9-Aug-99, to lugnet.robotics)
|
| |
 | | RE: Power steering for 8448
|
|
You should be able to get away with just a single rotation sensor. When you power up the RCX, you will not know the position of the steering. Now turn it one way until the rotation stops. You are now at the end point, and know the position of the (...) (27 years ago, 9-Aug-99, to lugnet.robotics)
|
| |
 | | Re: Handy Board software
|
|
(...) They're both 8-bit microcontrollers with a roughly similar set of peripheral functions (timer, ACD, serial port, etc). But the similarity ends there. The programming model for the H8 is compltely different from the 68xx series. (...) I don't (...) (27 years ago, 9-Aug-99, to lugnet.robotics, lugnet.robotics.rcx.legos)
|
| |
 | | Re: Using the Motor as a Tachometer
|
|
(...) I'm not a EE, but here's my take on the situation... Turning the motor increases the electrical potential (voltage) between its two contacts. If the motor isn't connected to anything, then its easy to turn - relatively little energy is (...) (27 years ago, 9-Aug-99, to lugnet.robotics)
|