 | | Wheel Setup for the 8880
|
|
Has anyone came up with a good way to use the wheel assemblies that come with the 8880 with smaller tires (the 68.8 x 40 Q)? -- Clay Aucoin (27 years ago, 12-Jun-99, to lugnet.robotics)
|
| |
 | | sorry about the message to adam longggg day
|
|
(27 years ago, 12-Jun-99, to lugnet.robotics)
|
| |
 | | Re: Wheel Setup for the 8880
|
|
(...) It is probably not feasible. You may note, however, that the 2x2 round plate with cross axle hole fits into the hole in the white steering gear from 8880. Perhaps this fact can be used for something useful? Let us know if you can get something (...) (27 years ago, 12-Jun-99, to lugnet.robotics)
|
| |
 | | Re: Wheel Setup for the 8880
|
|
Yeah but only the posts fit..and not really that good.. (...) -- ---- Clay Aucoin (27 years ago, 12-Jun-99, to lugnet.robotics)
|
| |
 | | Re: GORDON'S BRICK PROGRAMMER
|
|
(...) Gordon's Brick Programmer is easy to use. You have way more command choices than in Lego Mindstorms and the commands are easier to use. It also does not take as much time making a program on Gordon's Brick Programmer as on Lego Mindstorms. You (...) (27 years ago, 13-Jun-99, to lugnet.robotics)
|
| |
 | | Re: Problems with RCX, ROBOLAB and Macintosh
|
|
Hallo, I have tried NEW batteries in ir tower and RCX. I have tried to communicate in an absolute dark room with the same results. The ir tower is in near mode and the RCX in reset mode (take out the batteries and switch on the RCX - put the (...) (27 years ago, 6-Jun-99, to lugnet.robotics)
|
| |
 | | Anyone have any luck making a successful floating boat?
|
|
I was just wondering if anyone has had (or even tried) making a successful floating boat (not using the "Boat Really Floats" pieces)? -- Clay Aucoin (27 years ago, 14-Jun-99, to lugnet.robotics, lugnet.build)
|
| |
 | | Fw: Problems with RCX, ROBOLAB and Macintosh
|
|
I've seen this thread going, and going, and going; must be pretty frustrating. It seems like you said at one point that it works fine from a PC, is that right? If so, don't you have to use a serial adapter to connect the IR tower to a Mac? And if (...) (27 years ago, 13-Jun-99, to lugnet.robotics)
|
| |
 | | Re: Problems with RCX, ROBOLAB and Macintosh
|
|
Hallo Will, it can't be the adapter cable which is wrong. With NQC -the very good programming software from Dave Baum- I have no problem to contact the RCX. Downloading the firmware, sending programs, starting programs ... it's okay. Everything (...) (27 years ago, 14-Jun-99, to lugnet.robotics)
|
| |
 | | Re: Anyone have any luck making a successful floating boat?
|
|
(...) I've considered using empty air tanks from pneumatic LEGO sets as sort of 'pontoons'... my one quick test of this so far was too top-heavy (I only have three air tanks), but it seems like it should work, as long as the floats are far enough (...) (27 years ago, 14-Jun-99, to lugnet.robotics)
|