To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 5286 (-5)
  Re: Removing red led from light sensor..
 
Patrick Lawrence <pat@hpnc.com> wrote in message news:FD3pFv.DDF@lugnet.com... (...) Removing the LED makes it work over a wider range (0 to 100), but probably at a slight loss of low light sensitivity. There is an analysis of the subject in the (...) (27 years ago, 10-Jun-99, to lugnet.robotics)
 
  Re: Removing red led from light sensor..
 
It is actually easier to just place a beam in front of the sensor. The layout of the hole on the beam will block out the LED adn allow you to just use the sensor. DAN In a message dated 6/10/99 6:42:02 AM Eastern Daylight Time, mario.ferrari@edis.it (...) (27 years ago, 10-Jun-99, to lugnet.robotics)
 
  Re: Removing red led from light sensor..
 
(...) Ralph Hempel describes some non-destructive tricks to get better readings from a light sensor. This is the address: (URL) (27 years ago, 10-Jun-99, to lugnet.robotics)
 
  Re: A synchro-drive and a CyberDog
 
In lugnet.robotics, Hari Wiguna writes: <snip> (...) Yes, correct. You "drive" it more or less you'd do with a real dog. And when you pull up the leash, it stops. Mario (27 years ago, 10-Jun-99, to lugnet.robotics)
 
  Trouble getting VB sample prog working
 
Hello, I've been having trouble getting a couple of the various sample VB programs to work (such as the one that can be found on the official Mindstorms site) - every routine call seems to be coughing up this error: "Remember to call Init Comm or (...) (27 years ago, 10-Jun-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR