 | | Re: Fishing for a tasty linkage/gearing/robotic building thread...
|
|
(...) I am working on a LEGO color copier machine. I've been fooling with it for a couple of months now (not so much due to difficulty as to lack of free time). Physically, my copier is basically an XY plotter with four interchangable colored pens. (...) (28 years ago, 12-May-99, to lugnet.robotics)
|
| |
 | | Re: Fishing for a tasty linkage/gearing/robotic building thread...
|
|
Michael, If you only need to make right angle changes of direction how about a design where the robot does not turn. You could have one set of axles for forward/backward with 1 motor driving both sides so you go straight. Then to change direction a (...) (28 years ago, 12-May-99, to lugnet.robotics)
|
| |
 | | Re: Fishing for a tasty linkage/gearing/robotic building thread...
|
|
I would try using one motor to drive and a ratchet on one of the wheels. Then when you go in reverse, you turn. Time the motor power setting and turn rate until you get a good 90 degree turn. The other way would be to use some kind of line (...) (28 years ago, 12-May-99, to lugnet.robotics)
|
| |
 | | Re: Fishing for a tasty linkage/gearing/robotic building thread...
|
|
(...) I was toying around with something like this. A foot like thing would come down, lift the whole vehicle up off the ground, then turn it right or left 90 degrees (maybe even a variable angle), and set it back down. It does look like a three (...) (28 years ago, 12-May-99, to lugnet.robotics)
|
| |
 | | Light sensor help??Newbie!!!
|
|
Hi All! I have a problem with the light sensor using the included software. (Don't groan all you advanced programmers, please ;-> ) But anyway, the manual states and I quote" trigger the stack when the FIRST of TWO consecutive readings falls outside (...) (28 years ago, 12-May-99, to lugnet.robotics)
|