To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 4926 (-20)
  Re: Some comments (long)
 
(...) Assuming you use the ROM to receive things, which would be prudent in terms of space but not strictly necessary, the lengths of the opcodes in the message receiving code are determined by the lowest three bits of the opcode: 0 means length 0, (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some more comments and suggestions.
 
(...) That's a good pseudo-question. It would actually be quite easy to set up a focused group/list for this, as has been done for legOS, NQC, and pbFORTH; the viability is only dependent on the interest in having more room to breathe. Anything (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Removal of the LED in Light Sensors
 
There is a common operation on LEGO light sensors that involves removal of the LED. The belief is; If the LED is removed, then the sensor works better as an ambient light sensor. I have simulated the LEGO light sensor circuit with and without the (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  FW: Some comments (long)
 
-----Original Message----- From: Ralph Hempel [mailto:rhempel@bmts.com] Sent: Thursday, May 06, 1999 3:25 PM To: John A. Tamplin Subject: RE: Some comments (long) (...) Hmmm, as I understand it, the A/D sampling takes place periodically during the (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long)
 
(...) Unfortunately, the ROM code (as I understand it) does not implement any mechanism other than polling. I would like to do things like block a thread until a sensor value matched some criteria. The only efficient way to do that is to have the (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Lego Network Protocol questions
 
(...) I was under the impression you wanted to sync a clock to the rhythm of bit arrivals. You cannot do this. You can definitely sync a clock to the rhythm of byte arrivals. I was trying to point out this distinction to you. You must have been (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: LEGO light sensor schematic
 
(...) Sorry about that, I glued it back together with liquid plastic cement. I don't think it can take another operation and survive. I can't remember seeing a number inside and I was looking in there when you wedge the pc board in place. You might (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long) (was: Something else is needed, I think...)
 
Mark Tarrabain wrote in message <3730DE97.EFB3BF9A@l....bc.ca>... (...) It is probably true that a floating-point library cannot (should not?) be built into the firmware. It would probably be better for this to be supported by the compiler(s). But (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long)
 
(...) Could you explain what you mean by this, exactly? I would have figured that if a new interpreter is designed from scratch, the lengths of the opcodes could be hard-coded into the interpreter in some way. I was not suggesting that any existing (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long)
 
(...) Not that I disagree with the elegance of being able to define a class that implements a new way of reading a sensor; however, I thought I'd point out two issues you might want to consider: First, the ROM already contains a significant amount (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long)
 
At 18:22 06-05-1999 Thursday , you wrote: [...] (...) [...] Yes, that's a good idea since CyberMaster does accept a downloadable firmware, you can simply pretend it never existed and use all the CyberMaster specific opcodes as you wish. Laurentino (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Lego Network Protocol questions
 
(...) Sure, but you should be able to get the edge of the stop bit(s) to within 1/16th bit+interrupt latency (which I'd guess is tiny in comparison to the bit timing) which gives you the position of any other bit just as accurately (give or take (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long)
 
(...) Remember that Java's origins came from Oak, which was intended to operate a Universal remote control. JVM runs on many very tiny computers, and I am certain that a large subset of Java can be made to fit on the RCX and be a usable product. (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long)
 
(...) You have reiterated exactly what I expected would be one of the most popular reasons to want to implement a JVM for the RCX. I hope you don't think I'm against what you're attempting to do... it's just that I, like Kekoa, believe that the (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long)
 
So to preface my comments to Mark's message, I should say that even though I point out technical problems with what he proposes, I do not mean to imply that these technical problems cannot be overcome. (...) There are some technical issues that (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: interest in JVM porting effort
 
After thinking about it some more, I think it was silly to develop the OS and the JVM port simultaneously. The initial step should be to get it running under legOS, perhaps single-threaded without GC. After that is working, we can replace the OS (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Some more comments and suggestions.
 
(...) I concur with this opinion. I realize that the subject may be a bit prevalent right now but the alternative would be to develop a separate list for alternative firmware discussion, and I don't know how viable that would be. What follows is a (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long)
 
(...) Absolutely. What I have in mind is that the basic level of access is to the raw sensor value of the A/D converter and whether it is active or passive. The interpretation of that value would be done by other classes. For example, I would like (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Lego Network Protocol questions
 
(...) This is a possibility I hadn't considered, and it sounds reasonable to expect to see that effect at some point. I never tested how a second source affects echo reception, but it seems easy enough to test. If I get around to testing this I'll (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: interest in JVM porting effort
 
Oh, I guess I should say hello first. Hello. I've been lurking for months now, but haven't joined in because school has been kicking my butt timewise, hence an inability to build. Wicked, evil university. Anyways, the semester ends next week (...) (28 years ago, 6-May-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR