To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 4757
4756  |  4758
Subject: 
RE: LEGO light sensor schematic
Newsgroups: 
lugnet.robotics
Date: 
Sun, 2 May 1999 00:03:18 GMT
Viewed: 
3301 times
  
> Well I couldn't wait.  I broke down and broke into my Light sensor.  All I can
> say is don't do it!  The guy that figured out how to package this thing must
> wear a straight jacket.  You will break things getting it open.
> 
> Other than the already talked about upside down diodes, I found 2 pin numbers
> on the Opamp were switched and that was it.  I think it is all correct now. I
> fixed up the circuit and added some measured voltages to make things clearer.
> There is a little analysis added below the circuit for how I think it works.
> 
> I'd forgive this much complexity if it actually worked better, but I'm not all
> that impressed with it.  It never goes down much below 20 and who cares how
> linear it is.
> 
> http://www.plazaearth.com/usr/gasperi/light.htm


HaHa, I was so busy getting the next release of pbFORTH out that Michael
beat me to it. Anyways, good work! I have a little fix to extend the range of
the light sensor in % mode that involves blocking the light that comes
from the emitter. See:

<http://www.bmts.com/~rhempel/lego/lightsensor/default.html>

for details. I've got a %range of 6 (in a box) to 95 (pointing at a halogen
desk lamp 5' away) Your mileage may vary, but give it a try!

Cheers,

Ralph Hempel - P.Eng

--------------------------------------------------------
Check out pbFORTH for LEGO Mindstorms at:
<http://www.bmts.com/~rhempel/lego/pbFORTH/default.html>
--------------------------------------------------------
Reply to:      rhempel at bmts dot com
------------------------------------------------------



Message is in Reply To:
  Re: LEGO light sensor schematic
 
(...) wrong with it for me so I wouldn't have to. Well I couldn't wait. I broke down and broke into my Light sensor. All I can say is don't do it! The guy that figured out how to package this thing must wear a straight jacket. You will break things (...) (27 years ago, 1-May-99, to lugnet.robotics)

9 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR