 | | Re: Using Lego IR outside of Lego
|
|
(...) If your laptop has one of the newer (1997) or later super-io chips as the controller for the IR, you may be able to get it to communicate with the tower. The trick is to setup the chip into SHARP IR mode (which transmits data at 38.4k on a (...) (28 years ago, 23-Apr-99, to lugnet.robotics)
|
| |
 | | Re: SoCal LegoLand
|
|
In article <199904222202.SAA232...navy.mil>, Ken Hornstein <kenh@cmf.nrl.navy.mil> writes (...) and in article <371FBB6F.236FDCF8@ghg.net>, John A. Donaldson <jdonaldson@ghg.net> writes (...) I'm 56 and drove _past_ Billund last September without (...) (28 years ago, 23-Apr-99, to lugnet.robotics)
|
| |
 | | Re: pneumatic switch control
|
|
I just got my RIS as well as some pneumatic parts yesterday. The timing couldn't be worse as I'm in the middle of finals and can't spare much time for non-studying activities. However, your suggestion inspired me to take a study break and open up my (...) (28 years ago, 23-Apr-99, to lugnet.robotics)
|
| |
 | | Re: pneumatic switch control
|
|
(...) To connect the motor to the switch, use a piston arrangement (like a car engine). This can be done quite compactly. A single touch/light sensor and medium pulley wheel can be used to count motor revolutions (to determine when you've gone from (...) (28 years ago, 23-Apr-99, to lugnet.robotics)
|
| |
 | | virtual RCX-unit
|
|
Hello everybody! The most of RCX owners have only one RXC unit. So the created RXC-robot seems to be lonely and often does not communicate with the PC after downloading a program.. Have anyone ever think of programming a (or many) virtual RCX (...) (28 years ago, 23-Apr-99, to lugnet.robotics)
|