To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 2786 (+5)
  Re: Synchro drive in Lego
 
(...) Yeah, but I can't think of a good way to ratchet the assembly. -Paul (pspeed@augustschell.com) (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
 
  Unidirectional gearing - was Synchro drive in Lego
 
Here's a really simple (but not fool-proof way): Feed the motor output into a differential gear. The output from the differentials run out through beams and have a medium gear just outside the beam. Then suspend another beam from one end using a (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
 
  Re: Synchro drive in lego
 
(...) I've seen ratchets made with a pivoting gear rack element in contact with a 24 Tooth gear. Also, the small bungee racers had a ratchet mechanism also using several 16T gears. I'm quite curious to see what other variations of this platform (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
 
  Re: Synchro drive in lego
 
Yeah, I've made these sorts of ratchets before. The problem isn't so much making a ratchet as it is ratcheting the wheel assembly to the platform. If I had one of those free-spinning dark grey gears I could do it. I may finally have to break down (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
 
  Re: Pneumatic Tanks
 
Ian Sinclair wrote in message (...) That design was in response to a thread that was discounting pneumatics because their controls systems were "too big" and overall usefulness wasn't much. So I kinda wanted to undercut the complaint, since I like (...) (28 years ago, 14-Jan-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR