|
|
 | | Re: NXT's in Series
|
| (...) pbLua supports communication over the RS485(?) port. That's sensor port 4. Using that port, you can connect several NXTs together. You just need a cable that connects to several ports. Steve (17 years ago, 18-Sep-07, to lugnet.robotics)
| | | | | Re: NXT's in Series
|
| I suspect that with the proper software (and maybe a special cable), the I2C protocol can be used to network between NXT controllers. I2C is a multi master bus with collision detection, so it "should" work. It's just a SMOP [Small Matter of (...) (17 years ago, 18-Sep-07, to lugnet.robotics)
| | | | | Re: Serenity, an autonomous NXT-based boat
|
| (...) It's a good thought - in fact, my first attempt was to use the front treaded "flippers" on LNE/Packbot so that Packbot could drive onto a "floatation frame", and either power or deploy its own "water tread" propulsion. That idea fell afoul of (...) (17 years ago, 17-Sep-07, to lugnet.robotics)
| | | | | Re: NXT's in Series
|
| [Cross-posted to lugnet.robotics as it's on-topic there] (...) There's no absolutely transparent way to make a program running on one NXT address the sensor or motor ports of a 2nd (or 3rd, or 4th) NXT. However, a lot of solutions to this problem (...) (17 years ago, 17-Sep-07, to lugnet.technic, lugnet.robotics)
| | | | | Re: Serenity, an autonomous NXT-based boat
|
| Not that I've tried it (of course) but it seems that if were to use the treads with small paddles attached, it would push the splashing part to the rear, give skid steering, and sill provide good propulsion, similar to the corkscrew idea. Chain (...) (17 years ago, 17-Sep-07, to lugnet.robotics)
|
|
