Subject:
|
Matlab and NXT
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 8 Feb 2007 15:33:01 GMT
|
Original-From:
|
iacopo finocchi <PINEPINO@GMAIL.avoidspamCOM>
|
Viewed:
|
3945 times
|
| |
|
|
Hi,
i am a italian student. sorry for my english, it's very bad. I follow a
university project, about LEGO NXT. I must utilized matlab to create a program
for NXT and a I try to find a program to "translate" the program from matlab to
NXT. This program has not to be a remote control of NXT. Can you help me?
Thank's a lot.
|
|
Message has 4 Replies:
 | | Re: Matlab and NXT
|
| (...) It sounds like you want to make a program in Matlab, and compile it to run on the NXT. You do NOT want to make a program that runs on a PC, and is a remote control for the NXT. Right? This is NOT a simple task. I don't know much about Matlab, (...) (18 years ago, 9-Feb-07, to lugnet.robotics)
| | | Re: Matlab and NXT
|
| (...) Have a look to: (URL) a problem: the target is RCX and not NTX. Good look! Julio ***...*** Julio Abascal University of the Basque Country. Dept. of Computer Architecture & Technology (18 years ago, 10-Feb-07, to lugnet.robotics)
| | | Re: Matlab and NXT
|
| You might also look at (URL) I have not tried this toolset it appears to basically allow for a communication channel between MATLAB and the NXT. But it does not appear to "compile" MATLAB code into NXT Bytes or NXT code. Ed (18 years ago, 11-Feb-07, to lugnet.robotics)
| | | Re: Matlab and NXT
|
| (...) It is possible to create an special MATLAB Real Time Workshop Embedded Target for NXT, converting a Simulink model to say NXC. There is a document here (URL) describes the process. It is a rather big project by itself, but I'm sure some people (...) (18 years ago, 11-Feb-07, to lugnet.robotics)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
