To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 26592
26591  |  26593
Subject: 
Re: Copy the Tyco "terrain Twister" screw drive?
Newsgroups: 
lugnet.org.ca.rtltoronto, lugnet.robotics
Date: 
Wed, 6 Dec 2006 22:47:36 GMT
Viewed: 
2060 times
  
In lugnet.org.ca.rtltoronto, Calum Tsang wrote:
In lugnet.org.ca.rtltoronto, Rob Antonishen wrote:
I saw the Tyco "Terrain Twister"
http://www.tycorc.com/us/product.asp?category_type_id=22&id=11811&category_id=7819
advertised on TV and was intrigued by the drive mechanism.

It looks like it uses two counter-rotating screws/augers to move it
forward on bad surfaces like sand or snow. • [...]
Any thoughts on how this could be built as a robot drive base?

I've tried using flextube but haven't been able to duplicate this in Lego.

I don't know of any pieces which would fit the shape, but then of course, I'm
really not as up on my piece knowledge anymore.  There doesn't seem to be a
"worm segment" piece other than the actual regular worm piece Chris loves so
much.  There are those neat Castle stairpieces which are a "sweep of arc" but I
don't think you could make a giant worm out of them.

How about tirehub cylinders wrapped in flextube?

Calum

Well, there is this piece:
http://www.peeron.com/pics/inv/custpics/x210c01.1092552645.jpg
from this set: http://guide.lugnet.com/set/4970.

But even if you have an old Rock Raiders set sitting around (and why would
you?), you'd be wearing off all that nice chrome if you used it. Not to mention
that, if I recall correctly, it didn't have a technic axle connector, but just a
round hole for a friction (or non-friction) pin. So, I'd call it a close piece.
It might have worked better than the flex tubing, if only it'd been made a tiny
bit differently.

--
  David Schilling



Message has 1 Reply:
  RE: Copy the Tyco "terrain Twister" screw drive?
 
I remember seeing something like this made of lego a long time ago... I believe it was made with the flex tubes. Also, there's a GBC that uses an Arquimedian screw to lift the balls. I'm afraid I have no links to any of this things but maybe I've (...) (18 years ago, 7-Dec-06, to lugnet.robotics)

Message is in Reply To:
  Re: Copy the Tyco "terrain Twister" screw drive?
 
(...) I remember this toy! Wow, Tyco must be where old molds never die. (...) I don't know of any pieces which would fit the shape, but then of course, I'm really not as up on my piece knowledge anymore. There doesn't seem to be a "worm segment" (...) (18 years ago, 6-Dec-06, to lugnet.org.ca.rtltoronto, lugnet.robotics)

5 Messages in This Thread:


Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR