To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 24049 (-10)
  BT headsets and...
 
(...) My remarks were made comparing the power use of advertised BT chips vs 900-MHz and 2.4 GHz RF chip sets based on what was available a couple of years ago. To answer your question about headsets, I will speculate since I don't really know. But (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
 
  Re: for robots and industry: BlueTooth bad, Zigbee good - thanks for response
 
I have watched this thread for a while, but not "joined in" as I am not personally familiar with implementing Bluetooth. However, I have a question about the assertion that Bluetooth necessarily requires high power consumption; How well do coin cell (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
 
  Re: for robots and industry: BlueTooth bad, Zigbee good - thanks for response
 
(...) I should have made it more clear that all my BT remarks were in the context of use in the industrial or embedded spaces such as robotics where we get access to the hardware. Sure, millions of BT cell phones are shipping, but that's no help to (...) (21 years ago, 2-Jun-05, to lugnet.robotics)
 
  Re: wireless sensors, and battery life: time synch
 
(...) Yes -- and this is exactly Zigbee's target. BT was originally aimed at PC, PDA, peripheral communication, and it could have done well at that. Now I think it is eclipsed by the low cost and 10-100X better speed of 801.11b/g. Zigbee has from (...) (21 years ago, 2-Jun-05, to lugnet.robotics)
 
  Re: Nemesis4Lego controller
 
On Jun 1, 2005, at 7:31 PM, Gabriel Petrut wrote: <SNIP> (...) Gabe is correct, you can now find his page hosted by the LEGO Robotics Group of Ann Arbor at the following URL: (URL) (21 years ago, 2-Jun-05, to lugnet.robotics)
 
  Re: Nemesis4Lego controller
 
(...) Joe, the controller, as it is built right now, has two 3 pin ports exacly for sensors like ultrasonic, Sharp SP2D12, compass, accelerometer, etc. and servos. And I have in the works a module with a serial LCD. About my site. I just cheked it (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  Re: BlueTooth bad, Zigbee good
 
I'm biased, so here's my rebuttal: 1. The JB-22 is a great, affordable Bluetooth development kit under $200 USD. (URL) Class 1 Bluetooth devices have a range of +300ft. Anycom makes one that is rated at 330ft, but tests have shown that it can (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  more on Zigbee
 
(...) Good question. I was comparting BT to other RF systems. But you won't typically run your motors at 100% load all the time, either. So typically on a Lego bot, motors will be the main power users. Add BT to a Lego Bot and the battery life will (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  Re: BlueTooth bad, Zigbee good
 
(...) Anytime you have something listening for signals to wake up on, it will consume power. Even at 5 or 10 mA, you'll run through a standard AA battery pretty quickly - never mind coin cells. (...) When it came out, it was pretty cutting edge - in (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  BlueTooth bad: vendors crippling BT phones
 
(URL) much for the "use your BT phone as a modem with your BT PC or PDA". BT had a lot of hype for a long time but IMHO it's been killed for "small" users but such nonsense as the above, and the lack of affordable development tools. BT vendors (...) (21 years ago, 1-Jun-05, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR