 | | Nemesis4Lego controller —Titus Gabriel Petrut
|
| | | Danny & all, This was a prototype that I have built with regular parts. If there will be demand, I will make and order PCBs. The total cost of the parts is around $30. Add $10 for labor (and that is verry modest) and you'll get the price. The size (...) (19 years ago, 1-Jun-05, to lugnet.robotics)
|
| | | |
| | | | | Re: Nemesis4Lego controller —Joe Strout
|
| | | | (...) Gabriel, please do keep working on this! It's exactly the sort of thing I've been looking for for years. I get frustrated with the high cost and hard limits of the RCX; it sounds like your units would be far superior in terms of entry cost and (...) (19 years ago, 1-Jun-05, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Nemesis4Lego controller —Titus Gabriel Petrut
|
| | | | (...) Joe, the controller, as it is built right now, has two 3 pin ports exacly for sensors like ultrasonic, Sharp SP2D12, compass, accelerometer, etc. and servos. And I have in the works a module with a serial LCD. About my site. I just cheked it (...) (19 years ago, 1-Jun-05, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Nemesis4Lego controller —Jona Jeffords
|
| | | | On Jun 1, 2005, at 7:31 PM, Gabriel Petrut wrote: <SNIP> (...) Gabe is correct, you can now find his page hosted by the LEGO Robotics Group of Ann Arbor at the following URL: (URL) (19 years ago, 2-Jun-05, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Nemesis4Lego controller —Titus Gabriel Petrut
|
| | | | (...) I have updated the pages at the address mentioned above. I have added a page for each controller, since I have finnished Perseus. I am working on a robot that will use both controllers in a master-slave setup. I will post the results and (...) (19 years ago, 15-Jun-05, to lugnet.robotics)
|
| | | | |
