 | | Re: RCX and R/C combined
|
| (...) snip (...) I'm only intending to use standard gear motors. Great answear Mark, that's exactly what I wanted to know. Steve (22 years ago, 9-Apr-05, to lugnet.robotics)
| | |  | | Re: My First MOC
|
| (...) Rather than asking everyone to email you replies, you may want to look into subscribing to the group (perhaps temporarily) by email, via this URL: (URL) first doing this subscription setup: (URL) to get your confirmation code ) XFUT (...) (22 years ago, 9-Apr-05, to lugnet.robotics, lugnet.technic, lugnet.admin.general)
| | |  | | My First MOC
|
| Pictures should be forthcoming in a few days of my first official MOC, the überCrawler. This is a 2 RCX, 6 motor beast that turns by raising itself via a two-motor winch. It has four independently-powered tracks, coupled into a front and rear pair (...) (22 years ago, 9-Apr-05, to lugnet.robotics, lugnet.technic)
| | |  | | Gearbox
|
| Does anybody have diagrams, pictures, etc., regarding a "one-way" gearbox? This would have ideally one input and one output shaft, and the output shaft would turn the same direction no matter which direction the input was turned. Like a rectifier (...) (22 years ago, 9-Apr-05, to lugnet.robotics)
| | |  | | GPS Reality?
|
| Is the idea of a GPS sensor compatible to the sensor ports an absurd idea? I have a few old Garmin units, with RS232 ports on them. I know of people who have incorporated these units successfully into "real" robots, but that usually involves heavy (...) (22 years ago, 7-Apr-05, to lugnet.robotics)
| | |  | | Re: RCX and R/C combined
|
| (...) Here's a diagram of the RCX sensor port circuit: (URL) Feeding a voltage of up to +9V (or the RCX battery voltage) will not harm the port, as this is what it uses in Active mode (light or rotation sensor). You can actually use an external 9V (...) (22 years ago, 8-Apr-05, to lugnet.robotics)
| | |  | | RCX and R/C combined
|
| I've just been experimenting with my RCX to see if it can sense the output from the Lego RC unit. The experiment was fairly successful, I was just wondering though if putting 9v into a sensor port does it any good. Are their any risks in making such (...) (22 years ago, 8-Apr-05, to lugnet.robotics)
| | |  | | Re: Looking for the Mindstorms software.
|
| (...) No it is not incorrect. You do have to install the USB tower drivers in order for NQC and BricxCC to use the USB tower to talk to the brick. That is not the case for the Serial tower. You can get the tower drivers (along with the firmware) by (...) (22 years ago, 8-Apr-05, to lugnet.robotics)
| | |  | | Re: caster wheel design
|
| here's some raw pix of one completed robot, another in construction, and an idea for a third, all using the omniwheels: www.danbmil.com/lego I'll try to clean up the pix, put some captions etc. later - dbm ps note that the additional duplo blocks (...) (22 years ago, 8-Apr-05, to lugnet.robotics)
| | |  | | Re: caster wheel design
|
| (...) Hi Dan, Maybe, could you provide some pixs of the heavy robot you built using the omni wheels. Thanks, Hakim (22 years ago, 7-Apr-05, to lugnet.robotics)
| |