 | | Re: Replacement Firmware Released
|
|
(...) Agreed. For practical reasons, Ultimate Robolab implements the variable brake mode too. (22 years ago, 24-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Replacement Firmware Released
|
|
(...) I don't think this is a bug in the original firmware, but rather a protection against burning electronics parts in the RCX or dammaging motors flipping the motor directions too rapidly. Motors present some interesting electronics behaviour due (...) (22 years ago, 24-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Replacement Firmware Released
|
|
I'm pretty sure that variable strength braking is in fact the implementation in the standard firmware. Braking is proportional to the current setting of the power level. I think there may even be some ancient posts somewhere in Lugnet on this topic. (...) (22 years ago, 23-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Replacement Firmware Released
|
|
The behavior you've experienced is expected. Standard Lego firmware implements a 100 msec delay when you directly "flip" or change powered motor direction. I expect it is a bug (rather than design intent) that if you go through the stage (...) (22 years ago, 23-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Replacement Firmware Released
|
|
Hi Dan, (...) that is strange, are you sure? (...) That is what the ROM routines do, and firmwares like Lejos that rely on it. I would have thought the standard firmware does it in the same way. Jürgen (22 years ago, 23-Dec-04, to lugnet.robotics)
|
| |
 | | Re: RCX IR Transceiver and Sensor Port Circuits
|
|
Hi Mark, (...) I would also like to see your diagrams. (...) Please use GIF or PNG, jpegs are not so good for diagrams. Jürgen (22 years ago, 23-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Replacement Firmware Released
|
|
(...) Indeed, it vibrates fine if you set nMotorTransitionDelay = 0 Philo (22 years ago, 23-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Replacement Firmware Released
|
|
(...) Agreed. Beeing able to control break strength is an interesting feature, but it is incompatible with standard firmware. Maybe it should be controlled by a variable similar to bFloatDuringInactiveMotorPWM (22 years ago, 23-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Replacement Firmware Released
|
|
(...) I did exactly the same thing today, and found I needed a figure of about twenty to acheive reliable back and forth motion. I think it may be something to do with the fact that the rcx firmware(s) will not let you switch motor direction (...) (22 years ago, 23-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Replacement Firmware Released
|
|
I too am impressed with the amount of work that went into this release. After a few days playing around with it, I have a few comments: 1) braking seems to be proportional to power (at power=0, brake is not very effective) -- Lego firmware appears (...) (22 years ago, 23-Dec-04, to lugnet.robotics)
|