To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 21012
  Re: gear pulley/release system
 
I just thought of an idea, haven't had time to try it out but here it is. What if you were to have a sliding worm gear that would wind the arm up when the motor was powered forward and release it when the motor was powered reverse. Like I said, just (...) (21 years ago, 27-Jun-03, to lugnet.robotics)
 
  Re: gear pulley/release system
 
Quoting scott davis <rcx2man@hotmail.com>: (...) Some of my students did this very thing. They used one motor to wind up a spring which was then released to kick a ball. Worked well. Bruce (21 years ago, 27-Jun-03, to lugnet.robotics)
 
  Re: gear pulley/release system
 
(...) I did a device like this, where the motor ran a differential, which was then used to wind up and release the axle that did the work. One differential output shaft did the winding, and the wound-up axle was held for firing by a gear and ratchet (...) (21 years ago, 27-Jun-03, to lugnet.robotics)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR