Subject:
|
gear pulley/release system
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Wed, 18 Jun 2003 20:10:00 GMT
|
Original-From:
|
Richard Diaz <richdiaz99@yahoo.com>
|
Viewed:
|
911 times
|
| |
|
|
I have looked all over the forums and archives and
still have not found quite what I am looking for. A
cocking mechanisim for a cannon.
I need a 1x16 beam (the 'bolt', held by rubber bands)
to be pulled back and released down an 2x16 chamber
pushing out a small projectile (marble). I have to use
a single motor with gears/pullys/whatever... Sure I
can crank it back but how do I release the 1x16 beam?
This also needs to recycle after firing...
if you know of images or arcticles about this please
point me in the right direction...
thanks,
Rich
__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com
|
|
Message is in Reply To:
 | | version of firmware
|
| Where can i see the version (1.5 or 2.0) of the firmware that is loaded into an RCX? thanks, Rich ___...___ Do you Yahoo!? SBC Yahoo! DSL - Now only $29.95 per month! (URL) (21 years ago, 16-Jun-03, to lugnet.robotics)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
